- Part No: T1190
- Material: Polychloropren (neoprene)
- Colour: Black
- Number of teeth: 125
- Width (mm): 26
- Length (mm): 1191
- Qty: 1pc
- PTFE-infused jackets to reduce frictional losses and tooth shear.
- High grade HNBR rubber for superior heat and contamination resistance.
- Premium tensile members providing maximum strength.
- Aramid reinforced nylon jackets and backsides increase durability and lifetime.
- Genuine warranty equal to OE replacement interval.
- Suitable with:
- HONDA
- CIVIC
- Petrol 1.6L/88KW 1.6 (EK1, EJ6) D16Y4 EJ,EK,SO Front-Wheel Drive Sedan (10/95-09/00)
- CR-V
- Petrol 2L/108KW 2.0 16V 4WD (RD1, RD3) B20Z1 RD All-wheel Drive SUV (01/99-02/02)
- Petrol 2L/98KW 2.0 (RD1) B20Z1 RD All-wheel Drive SUV (04/99-02/02)
- Petrol 2L/109KW 2.0 4WD B20Z2 RD All-wheel Drive SUV (09/98-12/01)
- Petrol 2L/94KW 2.0 16V 4WD (RD1, RD3) B20B RD All-wheel Drive SUV (10/95-12/01)
- STEPWGN
- Petrol 2L/99KW 2.0 (RF1) B20B E-RF_,GF-RF_ Front-Wheel Drive MPV (05/96-09/00)
- Caution:
- Before any service work on the belt is begun to be sure that the motor or engine is switched off and cannot be started.
- Important:
- Check for worn tensioners and idler pulleys. This is the best time to replace these part these parts if needed.
- Belt Removal:
- Loosen adjustment or pivot bolts.
- Move adjustment unit to minimum position.
- Remove belt.
- Belt Installation:
- Place new belt loosely on pulleys. Do not pry onto pulleys.
- Tension belt according to manufacturer's instruction.
- Run drive 5 minutes and retension. Belts must be tight enough to prevent slipping when drive is fully loaded.
